Meen Green MGP-20 Owner's Manual - page 23
ELECTRICAL SYSTEM
Electrical System Safety
Remove key; disconnect battery cables by pulling out on
LARGE RED
battery quick disconnect handle
and read owner’s manual before adjusting or repairing unit. Always remove key and disconnect battery cables by
pulling out on
LARGE RED
battery quick disconnect handle
before working on this unit.
Always disconnect battery cables by pulling out on
LARGE RED
battery quick disconnect handle when
transporting unit.
Keep unit free of grass clippings, leaves and other debris.
DO NOT spray water to clean unit. Use only compressed
air. Wear adequate eye and hearing protection when
cleaning the unit.
Always wear safety glasses and protective gear near battery.
Use insulated tools.
Clean battery compartment, drive motor compartment,
mower deck, seat etc. of all dirt and debris. Do not spray
unit with water. Do not use, solvents, hard cleaners or
abrasives. Use only compressed air.
Avoid injury. With key in ON position mower blade can
engage when safety lever switch is engaged, even if drive
motor is not turning. Keep area clear of bystanders when
engaging clutch switch.
All maintenance and storage areas should be properly
ventilated in accordance with applicable fire codes and
ordinances to avoid fire hazards. Proper ventilation is
required to remove hydrogen gas from the area during
battery charging. (With Lead Acid Models)
The amount of hydrogen gas emitted depends on several
factors such as; battery charger output rate, battery charge
time and battery condition. Because of the highly volatile
nature of hydrogen gas and its propensity to rise and
accumulate at the ceiling in pockets, a minimum of 5 air
changes per hour is recommended. Consult applicable
fire and safety codes for the specific ventilation levels
requirement, as well as requirements for the use of explosion
proof electrical apparatus.
Never allow flames, sparks or smoking near batteries.
Keep batteries out of reach of children.
Always keep protective shields, covers and guards in
place and securely fastened. If they become damaged,
repair or replace immediately. Never modify or remove
safety devices.
Electrical System Information
The Mean Green Mower is powered by a 36 volt electrical
system. It consists of the following components:
MGP-20 Push Mower
1. Blade controller - (1)
2. Deck Motors - (1)
3. Digital battery display (1) (on limited models)
4. Lithium Energy Modules (LEMs) - 1
Component Maintenance
IMPORTANT: Maintenance for the various electrical
components found on the Mean Green Mower should only be performed
by a Mean Green Products trained technician.
17