Meen Green MGP-20 Owner's Manual - page 21
damage and deterioration, which could expose moving
parts or allow objects to be thrown. Frequently check
components and replace with manufacturer’s recommended
parts, when necessary.
Exercise caution when working under the deck as the mower blades are
extremely sharp. Wear gloves and use extra caution when servicing them.
Use only genuine Mean Green Mower parts to ensure that original standards are
maintained.
Always remove key and disconnect battery cables by pulling out on
LARGE RED
battery quick disconnect handle
before working on this unit.
Always disconnect batteries when transporting unit.
Keep unit free of grass clippings, leaves and other debris.
DO NOT spray with water to clean unit. Use only compressed
air. Wear adequate eye and hearing protection when cleaning the unit.
Always wear safety glasses and protective gear near battery.
Use insulated tools.
Regular Maintenance
Regular maintenance is the best prevention for costly
downtime or expensive, premature repair. The following pages
contain suggested maintenance information and schedules
which the operator should follow on a routine basis. For more
detailed information order the correct parts manual for your unit.
Remain alert for unusual noises, they could be signaling a
problem. Visually inspect the machine for any abnormal wear or
damage. A good time to detect potential problems is while
performing scheduled maintenance service. Correcting the
problem as quickly as possible is the best insurance.
Daily inspect mower for grass clippings and wire and string
tangles. The underside of the mower deck may collect a buildup
of grass clippings and dirt, especially when grass is wet or
has high moisture content. This build-up will harden, restricting
blade and air movement and will probably show a poorer quality
of cutting. Therefore it should be removed routinely.
To do this it will be necessary to raise and block the deck,
using jack stands or blocks, in the full up position and scrape the
build-up from underneath.
Some repairs require the assistance of a trained service
mechanic and should not be attempted by unskilled personnel.
Consult Mean Green Products when assistance is needed.
Torque Values: WARNING: Particular attention must be given to
tightening the drive wheel lug nuts and blade spindle
bolts. Failure to correctly torque these items may
result in the loss of a wheel or blade, which can cause
serious damage or personal injury. Call your Mean Green Products Dealer for assistance.
Torque values are given below:
Ft.-lbs. Nm
Wheel (lug) Nuts………65-75………..88.14-101.7
Blade spindle bolt bottom..50……………67.8
Electrical system
This mower operates on a 36 volt electrical system.
Refer to the Electrical section of this manual for detailed
information.
15