Modular FORM Installation Manual - page 2
2
OVERVIEW
Form® is a UL-listed configurable headwall system. This system includes multiple horizontal equipment channels
integrated into the fascia of the unit which provide mounting points for a variety of accessories. Included in the
system are medical gas and electrical services, as well as provisions for nurse call systems, communications and
future additional services.
This document gives installation instructions specific to units that are semi-recessed (built into the interior
building partition wall with only the panels being proud of the wall surface), as well as being mounted to the
floor. The illustrations shown in this document are examples which will be similar to but not exactly like all
headwalls in this category. Installation instructions for floating units (hanging from the surface of the wall but
not touching the floor) or surface mounted units (mounted to the face of an existing partition) are provided in
separate documents.
UNPACKING AND INSPECTION
1. Upon receipt of units and prior to unpacking, inspect shipping containers for damage. Document any
damage found and notify the carrier and Modular Services Company.
2. Locate the carton for the unit you wish to install. Labels at each end of the carton identify the unit type
and general description of contents, as well as the room number or area of installation (if applicable).
3. Unpack the unit from shipping container, taking care not to damage the unit.
4. Verify that all components are included, according to the packing slip.
5. Inspect the units for defects in materials or workmanship prior to installation. It is the responsibility of the
customer to report any damage or deficiencies to Modular Services Company immediately upon discovery.
PREPARATION
Review the final approved shop drawings and the submittal booklet, which will provide you with technical
details specific to your installation, such as:
• Equipment types and quantities
• Room numbers and location in the building (if applicable)
• Electrical requirements