Moffat TURBOFAN E31D4 Installation And Operation Manual - page 14

Cleaning 

12 

Cleaning Guidelines 

To achieve the best results, cleaning must be regular and 

thorough.  If any small faults occur, have them looked at 

promptly.  Don't wait until they cause a complete 

breakdown. 

NOTE: 

• 

Carefully read and follow the safety instructions on 

the label of the cleaning product to be used. 

• 

DO NOT use harsh abrasive scouring pads or 

abrasive detergents as they could damage the oven. 

• 

Ensure that any detergent or cleaning material has 

been completely removed after each cleaning. 

To keep your oven clean and operating at peak efficiency, 

follow the procedures shown below:- 

Oven Cleaning 

NOTE: 

• 

If the oven usage is very high, the cleaning 

procedure should be carried out on a more frequent 

basis. 

• 

Allow the oven interior to cool to approx 50˚C - 

120˚F before commencing cleaning. 

Stainless Steel Surfaces 

a.  Thoroughly clean the exterior surfaces of the oven 

with, a damp cloth moistened with a mild detergent 

solution, or a soft bristled brush. 

b.  Baked on deposits or discolouration may require a 

good quality stainless steel cleaner.  Always apply 

cleaner when the oven is cold and rub in the 

direction of the grain. 

Side Racks 

a.  Remove wire oven racks and bottom element guard. 

b.  Partially undo the rack securing screw (anti-

clockwise) securing side rack to the oven wall, until 

the rack is loose. 

c.  Pull side racks forward to disengage the location 

pins at the rear of rack from the rear wall of the 

oven and remove the racks from the oven. 

d.  Clean all racks 

with a mild anti bacterial detergent 

and hot water, using a soft bristled brush.

e.  Dry the racks thoroughly with a dry cloth. 

f.  To refit the racks, engage the locating pins at the 

rear of side rack into the locating holes in the rear 

of the oven. 

g.  At the same time locate the front of the rack over 

the rack securing screw and hand tighten the rack 

securing screw . 

h.  Refit the wire oven racks and bottom element guard 

to the oven. 

Lamp Glass / Fan Baffle 

a.  Remove the wire racks as shown previously. 

b.  Whilst holding the fan baffle in place, undo the lamp 

glass (anti-clockwise) and remove. 

c.  Pull the fan baffle forward off the location bracket at 

lower rear of the oven. 

d. Clean fan baffle 

with mild anti bacterial detergent 

and hot water solution using a soft bristled brush.

e.  Dry fan baffle thoroughly with a soft dry cloth 

before re-fitting. 

f.  Clean the lamp glass 

using a soft cloth with a mild 

anti bacterial detergent and hot water solution.

g.  Dry the lamp glass thoroughly with a dry cloth. 

h.  Refit the fan baffle onto the location bracket below 

the fan. 

i.  Whilst holding the fan baffle in place, refit the lamp 

glass, screw the glass in clockwise to secure the fan 

baffle in place.  Do not over tighten lamp glass. 

Always turn off electrical power at the 

mains supply before commencing cleaning. 

This oven is not water proof.  Do not use 

water jet spray to clean interior or exterior 

of the appliance. 

Caution 

Rack Securing 

Screw 

Fan  

Baffle 

Lamp 

Glass 

Location 

Bracket 

Unscrew Anti-Clockwise 

Rear  

Location 

Points