Moffat TURBOFAN E31D4 Installation And Operation Manual - page 7

Installation 

5 

Electrical Connection 

Each oven should be connected to an adequately protected 

power supply and an isolation switch mounted adjacent to, 

but not behind the oven and must be readily accessible to 

the operator.  This switch must be clearly marked and 

readily accessible in case of fire. 

Check the electricity supply is correct to as shown on the  

Technical Data Plate on the front right hand corner of the 

oven side panel. 

Ensure that the oven is fitted with the appropriate power 

cord and plug. 

Positioning and Levelling of Oven 

1.  Correctly locate the oven into its final operating position 

and using a spirit level, adjust the oven feet so that the 

oven is level and at the correct height. 

Initial Start-Up 

Before using the new oven; 

1.  For first time use of the oven, operate the oven for 

about 1 hour at 200°C / 400°F to remove any fumes or 

odours which may be present. 

2.  Please refer to the Operation Section of this manual for 

details on how to correctly operate and shutdown the 

oven. 

Commissioning 

Before leaving the new installation; 

Check the oven functions in accordance with the  

operating instructions specified in the ‘Operation’  

section of this manual. 

Ensure that the operator has been instructed in the areas 

of correct operation and shutdown procedure for the 

appliance. 

NOTE:  If for some reason it is not possible to get the 

appliance to operate correctly, turn off the 

power supply at the mains supply and contact 

the supplier of this appliance. 

This oven must be earthed / grounded. 

If the supply cord is damaged, it must be replaced by a 

suitably qualified person in order to avoid a hazard. 

Warning 

Reversing the Oven Door 

NOTE:  This operation should only be carried out by a 

suitably competent person. 

Remove the Oven Door Inner Glass. 

1.  Open the oven door and 

open the door inner glass. 

2.  Remove the screw securing 

the inner glass retaining clip 

and remove the clip. 

3.  Lift up the inner glass and 

remove, ensuring that the 

pivot spacer is removed 

from the lower inner glass 

pivot and retained. 

4.  Remove the black plastic 

plugs from the top and  

bottom of the door and fit 

to the holes where the  

inner glass pivots were  

removed from. 

Remove the Oven Door. 

5.  Remove the door roller catch and blanking plate from 

the inside of the door and swap these over. 

6.  Whilst supporting the door,  

unscrew and remove the top 

door pivot bolt from the top 

door hinge assembly. 

7.  Remove the door and lay on 

a flat surface or workbench. 

8.  Unscrew the screws securing 

the door handle and remove 

the door handle. 

9.  Remove the top door hinge 

and fit to the bottom  

opposite corner of the door. 

10. Remove the bottom door 

hinge and fit to the top  

opposite corner of the door. 

Fit Blanking Plugs. 

Remove Top  

Door Pivot Bolt. 

Remove Top Door Hinge 

Remove Handle  

Securing Screws 

Swap Roller Catch and 

Blanking Plate over. 

Remove Screw and 

Retaining Clip.