NAD T535 Owner's Manual - page 26
CONDITION
POSSIBLE CAUSES
POSSIBLE SOLUTIONS
No power.
• The power cord is disconnected.
• Plug the power cord into the wall outlet
securely.
The power is on, but the DVD player does
not work.
• No disc is inserted.
• Insert a disc. (Check that the DVD or, audio
CD indicator in the display window is lit.)
No picture.
• The TV is not set to receive DVD signal
output.
• Select the appropriate video input mode on
the TV.
• The video cable is not connected securely.
• Connect the video cable securely.
• Unit output setting and TV resolution
capabilities mismatch.
• Check TV capability.
• Check mode of connections (eg. S-Video,
Component etc.).
• Check unit Resolution setting according to TV
capability and mode of connection.
No sound.
• The equipment connected with the audio
cable is not set to receive DVD signal output.
• Select the correct input mode of the audio
receiver so you can listen to the sound from
the DVD player.
• The power of the equipment connected with
the audio cable is turned off.
• Turn on the equipment connected with the
audio cable.
• The AUDIO options are set to the wrong
position.
• Set the Digital Audio Output to the correct
position, then turn on the DVD player again
by pressing POWER.
The DVD player does not start playback.
• An unplayable disc is inserted.
• Insert a playable disc. (Check the disc type,
color system and regional code.)
• The rating level is set.
• Cancel the rating function or change the
rating level.
The remote control does not work properly.
• The remote control is not pointed at the
remote sensor on the DVD player.
• Point the remote control at the remote sensor
of the DVD player.
• The remote control is too far from the DVD
player.
• Operate the remote control closer to the DVD
player.
• The remote control batteries are dead.
• Replace the remote control batteries.
.
REFERENCE
TROUBLESHOOTING
26
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ