National Instruments NI 9512 User Manual - page 10
1-2
|
ni.com
Chapter 1
Introduction and Installation
What You Need to Get Started
Using the NI 951x Modules in Scan Interface Mode
Scan Interface mode enables you to use C Series modules directly from the LabVIEW
Real-Time Module. Refer to the
CompactRIO Reference and Procedures (Scan Interface)
book
of the
LabVIEW Help
for more information about using C Series modules in Scan Interface
mode.
To set up and use the NI 951x drive interface modules in Scan Interface mode, you must have
the following items:
The following software packages and documentation:
–
LabVIEW NI SoftMotion Module
–
LabVIEW Development System
–
LabVIEW Real-Time Module
–
NI-RIO driver software
Tip
Refer to the software documentation for installation instructions.
The following hardware and documentation:
–
NI 9512, NI 9514, or NI 9516 drive interface module
–
External power supply
Note
power supply requirements.
–
CompactRIO controller and chassis that support the RIO Scan Interface
or
–
NI 9144 distributed chassis