National Instruments NI 9512 User Manual - page 11
© National Instruments
|
1-3
Using the NI 951x Modules in LabVIEW FPGA
Interface Mode
LabVIEW FPGA Interface mode enables you to use C Series modules from LabVIEW FPGA
VIs. Refer to the
CompactRIO Reference and Procedures (FPGA Interface)
book of the
LabVIEW Help
for more information about using C Series modules in LabVIEW FPGA
Interface mode.
To set up and use the NI 951x drive interface modules in LabVIEW FPGA Interface mode, you
must have the following items:
The following software packages and documentation:
–
(Optional) LabVIEW NI SoftMotion Module
–
LabVIEW Development System
–
LabVIEW Real-Time Module
–
LabVIEW FPGA Module
–
NI-RIO driver software
Tip
Refer to the software documentation for installation instructions.
The following hardware and documentation:
–
NI 9512, NI 9514, or NI 9516 drive interface module
–
External power supply
Note
power supply requirements.
–
CompactRIO controller and chassis
Safety Information
Special Conditions for Marine Applications
Some modules are Lloyd’s Register (LR) Type Approved for marine applications. To verify
Lloyd’s Register certification, visit
ni.com/certification
and search for the LR
certificate, or look for the Lloyd’s Register mark on the module.
Caution
To meet radio frequency emission requirements for marine applications,
use shielded cables and install the system in a metal enclosure. Suppression ferrites
must be installed on power supply inputs near power entries to modules and
controllers. Power supply and module cables must be separated on opposite sides of
the enclosure and must enter and exit through opposing enclosure walls.