National Instruments NI 9512 User Manual - page 12
1-4
|
ni.com
Chapter 1
Introduction and Installation
Optional Equipment
National Instruments offers several options for connecting NI 951x drive interface modules to
external stepper drives or servo amplifiers including the following:
•
NI 9512-to-P7000 Stepper Drives Connectivity Bundle
—Connects the NI 9512 to the
P70530 or P70360 stepper drives available from NI. (NI part number 780552-01)
•
NI 9514/16 to AKD Cable
—Connects the NI 9514 or NI 9516 to the AKD servo drive and
AKM brushless servo motors available from NI.
(NI part number 781524-01)
•
NI 9512 to AKD Cable
—Connects the NI 9512 to the AKD servo drive and AKM
brushless servo motors available from NI.
(NI part number 781525-01)
•
NI 951x Cable and Terminal Block Bundle
—Connects the NI 951x module with the
37-pin spring terminal blocks.
(NI part number 780553-01)
•
DSUB and MDR Solder Cup Connectors
—Simplifies custom cable creation.
NI part number for DSUB connector: 780549-01
NI part number for MDR connector: 780551-01
•
DSUB to Pigtails Cable and MDR to Pigtails Cable
—Simplifies custom cable creation.
NI part number for DSUB cable: 193412-04
NI part number for MDR cable: 193413-04
Caution
Do
not
use the recommended module power supplies to power a drive.
Check your drive documentation for drive power supply requirements.
•
+24 V DC power supply
Note
Refer to the National Instruments Web site at
ni.com
for available power
supplies.
Refer to Chapter 4,
Accessory and Cable Connections
, for cable and terminal block pin
assignments. For additional information about these and other available products refer to the
National Instruments Web site at
ni.com
, or call your National Instruments sales
representative.