NComputing L300 Evaluation Manual - page 13

|

13

NComputing L300 Virtual Desktop  

Evaluation Guide

Installing a Second NComputing L300 Virtual Desktop

To install a second device simply follow the instructions above to attach a monitor, mouse, and keyboard to another 

L300 Virtual Desktop device. If you are using DHCP, then the device will automatically obtain an IP address for its use 

while the session is active. Just like the first device, you can also configure a static IP address.

From the administrator console you will see the second session listed below the first one. You can perform all the 

same functions on the second device just like the first one.

NOTE: If connecting over 25 users, monitor the Windows Server 2003 and Windows XP 536 MB paged memory limit. If paged memory usage starts to 

get above 515MB, we advise not connecting any further users. 

Create New Users with Microsoft Management Console

As a final step, you will need to create two new users in 

the Microsoft Management Console. These are the new 

users who will be using each of your virtual desktops.  

To do this you will need to go in to the user panel of  

the Microsoft Management Console and add them.  

An example of this is shown in the graphic below.