Northern Industrial Tools 998255 Owner's Manual - page 10
Page of 14
10
d. Secure the Motor, slide Flat Washers on four Bolts (#41), then slide the Bolts up through the
bottom of the Motor Mount Plate and the Motor. Secure in place with locknut.
e. Check if Motor and belt turns true. Hands turn the Drum Pulley (#49) and verify that the
Motor Pulley and Drum Pulley do not rub against any other part, and that the pulleys turn
true. Make adjustments to Motor location as required.
21. Mount the Outer Motor Base Cover (#43) to the Inner Motor Base Cover (#39) using three
Bolts (#46), Washers (#70) and Nuts (#71). Make sure that the power cord from the Motor to
the Switch (#45) does not come in contact with moving parts. (Figure Q)
22. The Cement Mixer assembly is complete. Go back and retighten all screws, nuts, and bolts.
OPERATION
1. Place the Cement Mixer on a solid, even surface capable of supporting the weight of the
machine and all materials placed within it.
2. Connect the Power Cord (#44) to an electrical outlet (or properly rated extension cord) with a
third, ground prong.
3. First start the mixer, and then add material to the Drum. Typical maximum quantities include:
2 gallons water, 3 shovels cement, 15 shovels aggregate rock using a size 3 shovel.
WARNING:
Do not attempt to move the Cement Mixer when it is full and/or in operation,
serious personal injury could occur.
4. Adjust the Drum angle by pulling out on the Degree Adjusting Arm (#20), disengaging the
locking pins, and push on Arm until the desired angle is reached. Re-engage the locking pins.
5. Flip the switch (#45) to the “ON” position.
6. Filling and emptying the Drum is best done with the Drum rotating.
WARNING:
Never leave the Cement Mixer running while unattended. Do not turn Mixer
Off while full of cement.
7. When finished, flip the Switch “OFF” position, and disconnect the Power Cord.
8. Turn the Drum angle as far down as possible to drain all fluids from Drum.
Motor (42)
Bolt & Washer
&Locknut
Motor base cover mounting
holes (typical of 3)
Switch (45)
Bolt & Washer & Nut
Motor Base Cover (43)
Bolt & Washer & Nut
Fig. P
Fig. Q