Northern Industrial Tools 998255 Owner's Manual - page 7
Page of 14
7
13. Move the Connect seal from the inside to make sure the holes of Drum Upper, Connector Seal,
Drum Lower align in a line, insert the bolt (#58) with washer (#57) through the holes and rotate
them by hand. (Figure F)
Note:
Make sure that eight screws be in place, and tighten with a wrench.
14. Mount each Mixer blade (#2) inside the assembled drum, the V-shaped bend in the Mixers
should point in the direction of the Drum rotation (clockwise). Insert Hex Bolt (#1) with Washer
(#3) from outside, then washer and Locknut (#5). Tighten with a wrench. (Figure G, H)
15. Insert the handle (#64) into support bracket (#25) hole from one side. Slide Washer (#63)
onto the handle from the other side, insert Pins (#67) into the holes, bend the Pins outward so
it does not fall out. (Figure I)
16. Mount the Degree Adjusting Plate (#19) to the Iron Tube (#18), using two Hex Bolts (#24) with
washer (#27) inserted from the outside, and tighten with a wrench. (Figure J)
Mixer Blade
Mount holes
Drum Upper (4)
Fig. E
Connect Seal (6)
Align the holes
(Figure F)
Bolt (58) &Washer (57)
Fig. G
Fig. I
Handle (64)
Support bracket (25)
Fig. H
Mixer blade (2)
(Figure J)
Ring (17)
Iron Tube (18)
Ring (17)
Locking pin hole
Degree adjusting
plate (19)
Bolt &Washer
&locknut
Fig. D
Connect Seal (6)