Northern Industrial Tools 998255 Owner's Manual - page 6
Page of 14
6
ASSEMBLY
(Recommend that 2 people assist in assembly)
1. Place Stand (#30) onto Hinge Bracket (#34) so that bolt holes line up as shown in Figure A.
2. Insert Hex Bolts (#26) with Washer (#27) through holes from one side, then Washer (#27)
Lock Nut (#23) from the other side, and tighten with a wrench.
3. Insert Support Bracket (#25) onto Stand (#30) so that bolt holes line up.
4. Insert Hex Bolts (#26) with Washer (#27) through holes from one side, then Washer (#27)
Lock Nut (#23) from the other side, and tighten with a wrench.
5. Place Stand upright as shown in Figure B.
6. Place Wheel (#33) onto Hinge Bracket axle, and slip on the washer (#32) after the wheel.
7. Next insert Pins (#31) into the Hinge Bracket (#34) axle holes, outside each Flat Washer.
That is, the pin should be touching the washer, not the wheel.
8. Bend each side of the Pins outward so they do not fall out. (Figure B)
9. With two people, set the Drum Lower (#8) with attached Support Arm assembly into Stand
assembly so that the Shaft (#35) is on the wheel side and the Iron Tube (#18) is on the
Support Bracket (#25) side of the assembly. (Figure C)
10. Insert Hex Bolts (#59) with Washer through holes from one side, then Washer, Lock Nut from
the other side, and tighten with a wrench.
11. With the help of another person, attach Connector Seal (#6) to the Drum lower (#8), make
sure that the holes in both align. This Connect Seal must be flat on the Drum lower to ensure
a proper seal. (Figure D)
12. Carefully place the Drum Upper (#4) onto the Connector Seal. Make sure that the holes in
both align. (Figure E)
Note:
When placing the Drum Upper, align the Mixing Blade mounting holes in the side of the
drums as shown in Figure E. If they are too far away from each other, the Mixing Blades holes
will not match up with the mounting holes on the Drums.
Fig. A
Stand (30)
Bolt M8X70 (26)
Support bracket (25)
Washer Φ8 (27)
Hinge bracket (34)
Lock Nut M8 (28)
Pin (31)
Wheel (33)
Fig. B
Fig. C
Iron Tube
(18)
Shaft (35)
Bolt &Washer
&Locknut
Bolt &Washer
&Locknut