O-Synce MIXpro Quick Start Manual - page 10
Setting mode: Press and hold A for 5 seconds.
> UNITS: KM blinks. Press A or D to switch to Miles (MI). press B to confirm.
> GENDER: F blinks. Press A or D to switch to Male. press B to confirm.
> WGT KG (Weight): 68 blinks. Press A (+) or D (-) to change the value. press B to confirm.
> ZONES (Training zones): OFF blinks. Press A or D to switch it ON, if you want to use the
Training zones. press B to confirm
If Training Zone ON:
ZOTONE (beeper): OFF blinks. Press A or D to switch it ON, if you want the warning signal.
press B to confirm
> PC PAIR: OFF blinks. Press A or D for ON, to activate the PC connection. If you want to
use the SAS analyse software with the MAXpc USB-Stick. Press B to confirm.
> PAIR (Sensor-pairing): PUSH blinks. Press A or D to activate the search for the (switched
on) sensor. While the MIXpro scans for new sensors, the sensor icons blink. The icons are
solid on the display when paired.The watch will exit automatically to the Stop watch mode
when all active sensors have been found.
The Heart rate belt is already paired. Press C until the Train page appears. The heart rate
icon appears on the screen when the sensor is paired.
SET UPSENSORS (OPTIONAL)
IMPORTANT: If you purchas an accessory you have to pair all sensors together
again together!
_ Please make sure that all to be paired sensors are switched on and in range (3 m).
PARAMETER
After the pairing the sensors of your choice you have to re-do the setting mode again.
SETTING MODE: Press & Hold A for 5 seconds.
And now you can change and set the values like shown in the diagram
Confirm with B or exit anytime by pressing C.
ROLLING CIRCUMFERENCE
The wheel circumference can be done by rolling the wheel once or if you take the values
shown in the ERTRO-chart named with L below:
_9