O-Synce MIXpro Quick Start Manual - page 20
7 HISTORY MODE
The MIXpro holds up to 100 laps and up to seven hours of exercise files and stores workout
data based on the type of workout, the accessories used, and your training settings.
Press C until the DATA mode appears.
VIEWING WORKOUT HISTORY
On the DATA mode, press D (+) and A (-) to scroll through your saved runs and workout
data.
Press B to display the start time for that run.
Press D (+) and A (-) to view the rest of the run data depending on which accessories, set-
tings and training zones were used: Total run time, Total distance, Total steps, Total calories
and Time in each zone (ZONES must be set to ON).
Press B from any of these pages to view the next level of history data. Press D (+) and A (-)
to view the available data pages: Average lap time - Average lap speed - Average heart rate.
Press B from any of these pages to view the next level of history data and details for each
lap in your workout. Press D (+) or A (-) to view the available data pages.
DELETING WORKOUT HISTORY
On the DATA mode, press D (+) or A (-) to scroll through your saved runs to the run you
want to delete. Press and hold D to delete a single run. Continue to hold D to delete all runs.
No DATA appears.
MANAGING MEMORY
The MIXpro holds up to 100 laps and up to seven hours of exercise files. Periodically upload
data to your computer using the MAXpc and the SAS sw. When there is approximately one
hour of memory remaining, the Lo MEM warning appears on the MIXpro screen in Train
mode.When the memory is full, the Full MEM warning appears, and the MIXpro stops recor-
ding data.
8 PC SAS SOFTWARE
With the optional MAXpc stick you can use the free SAS Software to store and analyze
your workout data. Go to to download area on www.o-synce.com – support – downloads –
SAS. Follow the instructions and install the soft ware and the needed driver for the MAXpc
stick. Connect the MAXpc stick to an available USB port on your computer. Bring the MIXpro
within range (3 m) of your computer. Verify there are no timers running or active training ses-
sions.
_19