O-Synce MIXpro Quick Start Manual - 00´00´´
When finished, press B to advance to the REPEAT setting
Press D (+) and A (-) to turn on or off the repeat function. Press B to advance to TIMER 2
settings.
Press D (+) and A (-) to turn on or off the TIMER 2 function.
Repeat the steps from TIMER1 to set TIMER 2. When finished, press mode to resume
Timer mode.
USE OF THE COUNTDOWN
TIMER 1 START
press A
TIMER 1 STOP
press A
TIMER 1 RESET
press & hold D
USING TIMER REPEAT
Set the timer to REPEAT to automatically restart the timer after it beeps.
If both T I M E R 1 and TIMER 2 are active, the repeat function runs
TIMER 1 > TIMER2 > TIMER 1 > TIMER 2, and so forth until you press A.
TIMER 2 starting values (if active): press B
SETTING OF THE COUNTDOWN
NOTE: You can’t get in this mode if the TIMER 1 is not on the starting value (still running or
stopped!)
Change the TIMER-setting mode: press & hold A for 3 secunds
The starting value of the TIMER 1 will be shown.
When the hours blinks. Press A (+) or D (-) to change the values. Press B to confirm.
B
B
A
TIMER
00´00´´
TIMER 2
00´00´´
TIMER 1
00´00´´
TIMER 1
Laps
START/
A
00´00´´
TIMER 1
STOP/
A
00´00´´
TIMER 1
START/
00´00´´
TIMER 1
D3
BEEP!
_17