O-Synce MIXpro Quick Start Manual - page 14

ference and receiver distance from transmitter. Strong electromagnetic fields and some 2.4

GHz wireless sensors can interfere with your heart rate monitor. Sources of interference

may include very high voltage power lines, electric motors, microwave ovens, 2.4 GHz cord-

less phones, and wireless LAN access points. After you move away from the source of inter-

ference, your heart rate data should return to normal.

NOTE: 

Stay 10 m away from other ANT sensors while pairing. Bring the MIXpro within range (3 m)

of the heart rate

monitor while pairing. If the problem persists, replace the battery. 

TO REPLACE THE BATTERY:

1 Locate the circular battery cover on the back of the sensor.

2 Use a coin to twist the cover counter-clockwise until it is loose enough to remove.

3 Remove the cover and replace the battery with the positive side facing up.

NOTE: Be careful not to damage or lose the o-ring gasket on the cover.

4 Use a coin to twist the coverback into place.

MAXRUN FOOT POD SENSOR (OPTIONAL)

The MIXpro is ready to use with the MAXrun foot pod sensor for running and walking.The

MACRO 2SX spe for speed on the bike and MACRO 2SX cad for cadence. For more infor-

mation about optional accessories, go to www.o-synce.com. You can also contact your o-

synce dealer to purchase accessories.

SWITCHING OFF THE SENSORS

After 30 minutes of inactivity, all sensors are automatically powers off to conserve the bat-

tery.

O

P

EN

CR2032

3V

+

_13