Oce ColorWave 300 User Manual - page 7
■
Do not remove covers and panels that are fixed to the machine. Some machines have
a high-voltage component or a laser beam source inside that could cause an electric
shock or blindness
■
Do not modify this machine, since this could cause fire, electric shock, or breakdown.
If the machine contains a laser, the laser beam source could cause blindness.
Caution
■
Do not carry out maintenance activities on components and maintenance materials
other than the components and materials that are mentioned in the user manual.
■
Do not place any liquids on the machine.
■
Do not open any door while the machine starts up or runs, unless the operator panel
displays a message asking you to open one or more doors.
■
Only use maintenance materials or other materials for their intended purpose.
■
To avoid any risk, only properly qualified and trained service technicians are allowed
to modify the machine.
■
Do not bridge any mechanical or electrical circuit breakers.
Note
■
Keep maintenance materials away from children.
Power cord
Warning
■
Do not scratch, abrade, heat, twist, bend, place a heavy object on or cause any other
damage to the power cord. The use of a damaged power cord (exposed core wire,
broken wire, for example) could result in a fire or breakdown. If you find any of these
conditions, immediately turn OFF the power switch and unplug the power cord from
the power outlet. Then call your authorized service representative.
■
Only use the mains connector cable that was supplied with the machine.
Power source
Warning
■
Do not connect the machine to a mains voltage that differs from the value as stated
on the power marking label.
Note
■
If connection to a different mains voltage is required, contact your authorized service
representative.
Power plug
Warning
Chapter 1 - Safety information
7
Instructions for safe use