Oce ColorWave 300 User Manual - page 8
■
For machines that are connected via a wall socket: Place the machine close to a wall
socket that is easily accessible. The power plug is intended to serve as a disconnect
device.
Grounding
Warning
■
Connect the power cord to an electrical outlet (wall socket) that is equipped with a
grounding terminal.
Installation
Warning
■
Make sure that the machine is placed on a level, horizontal surface of sufficient strength.
Do not place this machine on an unstable or tilted bench.
■
Do not place this machine in a location that is subject to lots of vibrations and shocks.
■
Do not use flammable sprays, liquids or gases near this product, because this could
cause a fire.
Ventilation
Caution
■
The machine can produce odors of exhaust air when you:
- use this machine in a poorly ventilated room for a long time
- produce large amounts of copies or print
Therefore, make sure that you ventilate this room well. Do not block the ventilation
openings of the machine.
■
Do not place the machine in rooms which are too small and insufficiently ventilated.
See the Product Safety Data Sheet of the machine for the ventilation requirements.
Actions in response to troubles
Warning
■
When a piece of metal, water or any other similar foreign matter gets inside the ma-
chine, immediately turn OFF the power switch and unplug the power cord from the
power outlet. Then call your authorized service representative.
■
Immediately stop using the machine if the machine becomes excessively hot, emits
smoke, or produces unusual odors or noises. Immediately turn OFF the power switch
and unplug the power cord from the power outlet. Then call your authorized service
representative.
Caution
■
Stop using the machine if the machine was dropped or a cover was damaged. Imme-
diately turn OFF the power switch and unplug the power cord from the power outlet.
Then call your authorized service representative.
Chapter 1 - Safety information
8
Instructions for safe use