Oce im3530 Operator's Manual - page 3
EPA
E
NERGY
S
TAR ® (MFD)
The United States Environmental Protection Agency (EPA) has introduced a voluntary program, the
E
NERGY
S
TAR program, to encourage the widespread and voluntary use of energy-efficient technologies that enhance
the workplace, improve product performance and prevent pollution. As an
E
NERGY
S
TAR Partner, the Océ
North America, Corporate Printing Division has determined that this copier model meets the
E
NERGY
S
TAR
guidelines for energy efficiency.
E
NERGY
S
TAR guidelines for this class of copier require
E
NERGY
S
TAR copiers to have a ‘Sleep Mode’
feature that automatically makes the copier enter the sleep mode after a period of inactivity. The copier must also
automatically change to a ‘Low Power Mode’ (Automatic Energy Save) after a period of time since the last usage.
Specifically, this copier complies with the following requirements.
im3530/im4530 Copier model (Base model)
‘Automatic Energy Save’-
The copier consumes less than 139.75 W (im3530)/178.25 W (im4530)
during Energy Save.
‘Automatic Energy Save’ Default Time-
The default time for the ‘Automatic Energy Save’ is 15 minutes.
‘Off Mode’
The copier consumes less than 15 W (im3530)/20 W (im4530).
‘Off Mode’ Default Time-
The default time for the ‘Off Mode’ is 60 minutes (im3530)/90 minutes (im4530).
im3530/im4530 Copier/Printer + Fax model (Multifunction model)
‘Automatic Energy Save’-
The copier consumes less than 184.75 W (im3530)/223.25 W (im4530)
during Energy Save.
‘Automatic Energy Save’ Default Time-
The default time for the ‘Automatic Energy Save’ is 15 minutes.
‘Sleep Mode’
The copier consumes less than 80 W (im3530)/95 W (im4530) in the ‘Sleep Mode’.
‘Sleep Mode’ Default Time-
The default time for the ‘Sleep Mode’ is 60 minutes (im3530)/90 minutes (im4530).
Note1- The default setting for the ‘Off Mode’/‘Sleep Mode’ and ‘Automatic Energy Save’ can be changed. See
the User Functions Guide to change the default settings noted above.
Note2- For Base model, when the copier enters into the off mode, the power switch is automatically turned off.
Turn the power switch on again to use the copier.
Note3- For Multifunction model, if the Fax or printer data is received in the sleep mode, the copier starts warming
itself up and prints out the data when it becomes ready. Also, when the start button or the energy saver
button on the control panel is pressed, the copier starts warming itself up.
Note4- If ‘Automatic Energy Save’ and ‘Off Mode’/‘Sleep Mode’ have the same setting time, ‘Off Mode’/‘Sleep
Mode’ takes priority.
In accordance with EPA
E
NERGY
S
TAR program guidelines, Océ recommends the following recycled paper.
Great White MultiUse 20 paper
If you have any questions regarding the use of recycled paper or some recommended types of recycled paper,
please contact your authorized Océ dealer.
E
NERGY
S
TAR is a U.S. registered mark.