Oce WP36/50 Operation Manual - page 32
Chapter 3 Using the Operator Panel
3-11
This section explains the procedure for using the menu selec-
tion system. The menu selection system is activated by the
MENU
key while the printer is
Ready
.
2.2.1 Printing the Menu Map
The printer prints a full list of menu selections. Note that
menus indicated on the list may vary depending on which op-
tion units are installed on the printer.
Press the
MENU
key.
Press the or key repeatedly until
Print Menu
Map
appears.
Press the
ENTER
key. A question mark (
?
) appears.
Press the
ENTER
key again. The printer prints a
menu map.
Figure 3-2
2.2.2 Printing Status Page
If you want to check the printer’s current status, including
memory available and option settings, you can find the infor-
mation you need on the status page.
Press the
MENU
key.
Press the or key repeatedly until
Status Page
appears.
Press the
ENTER
key. A question mark (
?
) appears.
Press the
ENTER
key again. The printer prints a
status page.
For a full description of the status, see the following sample
status page.
The following is a sample status page. The numbers below re-
fer to the contents explained on the next page.
Figure 3-3
When the Network Status is turned on, the Network Interface Sta-
tus Page will be printed after the Printer Status. (See
page 3-20
.)
2.2 Using the Menu Selection System
Menu Map
Menu Map ?
1
2
3
4
MENU MAP
Status Page
Status Page ?
NOTE
1
2
3
4
KIR
Test pattern
ON
Memory
Installed Options
Network Status
Emulation
Toner Gauge
0
100
Interfaces
Hardware Information
Page Information
Error Log
STATUS PAGE
Firmware Version: Released:
1
3
5
7
8
2
4
0
A
9
6