Oce WP36/50 Operation Manual - page 91

Chapter 5  Maintenance

5-3

Remove the seal from the rear of the old waste toner

box, and then close the opening of the box with the

seal. Seal up the old waste toner box with the sup-

plied plastic bag and dispose of it.

Figure 5-11

Gently pull the cleaning knob as far as it will go, push

and pull it several times, and then push it back in.

Figure 5-12

Take out the new grid cleaner from the protective

bag, and then remove the cap from the grid cleaner.

Figure 5-13

Pull the main charger approximately 5 cm (2 inches)

out.

Figure 5-14

While avoiding the main charger roller (A) to be in

contact with the grid cleaner pad, push and pull the

main charger several times. (Do not push the main

charger all the way in. Otherwise, water from the

pad will cause the main charger unit to become we

and this may affect printing.)

Figure 5-15

When the grid is clean, remove the grid cleaner from

the printer and dispose of it. The grid cleaner is not

re-usable.

Fit the new waste toner box to the printer.

Figure 5-16

10

11

12

13

14

(A)

15