OCEAN PRESENCE OPT-06SD/HD User Manual - page 18
OceanCam User’s Manual
Version: 2.0 7/16/13
Ocean Presence Technologies
Copyright ©2011-2013 All Rights Reserved.
Page 18
5.0 SYSTEM ACCESSORIES
5.1 U
NDERWATER
L
IGHTING
The optional underwater lighting system
employs three banks of six LED (light
emitting diodes). They should be mounted
off the camera and out of the field of view.
The lights are powered from a separate 48
VDC underwater cable. Plug the lights in to
the furthest right connector and the power
to the connector to its left.
The light banks can be mounted top-to-
bottom (as shown above) or side-by-side
using the swivel mounts. The light bank
with the power cable needs to be
positioned as to reach the connector at the
rear of the housing.
When wiring single connector
power cables to 48 VDC batteries,
be careful to maintain proper
polarity.
DO NOT PLUG IN OR REMOVE THE
LIGHTING POWER CONNECTORS
WHILE UNDERWATER WHEN THE
POWER IS ON!
The lights can be remotely controlled over
the network. This is done with the use of a
special lighting controller board inside the
housing that is attached to the camera.
The alarm and triggers have been
preconfigured to work with the lighting
controller. The operation of the lights can
be controlled using the manual triggers or
through timer schedules.
5.2 H
YDROPHONE
The optional underwater hydrophone is
attached in port #1 to the left side of the
rear of the housing. The audio cable is
plugged into the camera.
Microphone controls can be found in the
Camera/Common tab. If you change the
Audio codec setting, click Refresh on the
Web browser to reflect the change on the
opening main viewer page.
The volume level of the audio input is
adjustable from –10 to +10. The bit rate of
audio is G.711 (64kbps), G.726 (40kbps),
G.726 (32kbps), G.726 (24kbps) or G.726
(16kbps) can be selected. Select On to use
dynamic range compressor.
N
OTE
: N
O AUDIO IS OUTPUT IF
JPEG
OR
JPEG/F
LASH IS USED FOR THE
P
LUG
-
IN
FREE VIEWER
.