OCEAN PRESENCE OPT-06SD/HD User Manual - page 28
OceanCam User’s Manual
Version: 2.0 7/16/13
Ocean Presence Technologies
Copyright ©2011-2013 All Rights Reserved.
Page 28
8.6.3 Camera Components
1. LAN (network) port (RJ-45) Connect to a 10BASE-T or
100BASE-TX network using a network cable
(UTP,category 5). When using an HPoE system to
operate the camera, connect a power feeding device to
this port.
2. SD memory card slot used for an optional SD memory
card. Images captured by the camera can be stored into
an inserted memory card. Be sure that the printed side of
a memory card and the product specifications label face
in the same direction, and then insert the card firmly into
the slot.
3. Microphone input terminal (minijack, monaural)
4. Line output terminal (minijack, monaural)
5. Factory reset button. The camera can also be reset to
the factory setting by turning on the power while pressing
the reset switch with a needle/paper clip.
6. I/O (Input/Output) port. Provides two sensor inputs and
one alarm output.
7. POWER indicator. When the camera receives power, a
system check is run internally in the camera. The
indicator lights up when the camera is operating
normally.
8.
NETWORK indicator (green/orange) The indicator lights
up or flashes when the camera is connected to the
network. The indicator is off when the camera is not
connected to the network. When 100BASE-TX is
connected, the indicator turns green. When 10BASE-T is
connected, the indicator turns orange.
8.7 H
OUSING
S
PECIFICATIONS
Glass Dome
60% spherical glass dome specially designed to maximize the camera’s optics
Max. depth
180 feet (55 meters)
PoE cable range
Standard: 320 ft (100 m)
Extended: 660 ft (200 m)
Connectors
Underwater-mateable connectors allows housing to be removed for maintenance
Moisture control
Silica dry bags
Size (L x W x H)
11.85” (301 mm) x 10.25” (260 mm) x 13.86” (352 mm)
Weight
24 lbs (9.5 kg)