Oceanic GEO 2 Operating Manual - page 68

68

•  If the SS was set for OFF or Timer, the display will not appear.

•  In the event that you descend 10 FT (3 M) deeper than the Stop Depth for 10 seconds 

during the countdown, or the countdown reaches 0:00, the No Deco Main screen 

will replace the SS Main screen which will reappear upon ascent to within 5 FT (1.5 

M) deeper than the Safety Stop Depth set for 1 second.

•  In the event that you enter Deco during the dive, complete the Deco obligation, then 

descend below 30 FT (9 M); the SS Main will appear again upon ascent to within 5 

FT (1.5 M) deeper than the SS Depth set for 1 second.

•  If you ascend 2 FT (0.6 M) shallower than the SS Depth for 10 seconds prior to 

completing it, the SS will be canceled for the remainder of that dive.  

•  There is no Penalty if you surface prior to completing the SS or ignore it.

If set for Timer On:

Upon ascending to 20 FT (6 M) for 1 second on a No Deco dive in which Depth exceed-

ed 30 FT (9 M) for 1 second, 1 beep will sound and a Run Timer will appear (if set On) 

displaying 0:00 (min:sec) until started.  

•  If the SS was set for Off or On, the Timer display will not appear.

•  If you descend deeper than 30 FT (9 M) for 10 seconds, the No Deco Main will 

replace the Timer screen which will reappear upon ascent to 20 FT (6 M) for 1 

second. 

•  If you ascend above 10 FT (3 M) for 10 seconds, or enter Deco, or a High O2 alarm 

condition occurs (100%), while the SS Timer is active, the SS Timer will be disabled 

for the remainder of that dive.