Oceanic OC1 Operating Manual - page 163

163

Data Retention

When the OC1 battery is removed, settings and nitrogen/oxy-

gen calculations for repetitive dives will be retained in volatile 

memory until a new battery is installed.  You will have the choice 

of saving or deleting the data (refer to page 166).  The Com-

pass will need to be calibrated after the new battery is installed 

(refer to page 146).

All parts needed for the battery change that follows are provid-

ed in the OC1 Battery Kit available at your Authorized Oceanic 

Dealer as Oceanic PN 04.6175.35.

OC1 Battery Removal

•  There is no need to remove the straps.

•  Remove the (4) retaining screws located on the back of the 

watch case (Fig. 161) by turning them counter clockwise 

with a small flat tip 3mm screw driver.

•  Carefully separate the front and back sections (Fig. 162).  

The Battery may fall out.  DO NOT pry apart with tools.

•  Turn the case to one side to drop the Battery into your 

hand. If necessary, gently loosen it with the tip of your 

finger.  DO NOT use tools to pry it out, or short the 

positive (+) top of the Battery (Fig. 163a) to the negative 

( - ) contact under it. 

•  Discard the Battery according to local regulations 

governing disposal of Lithium batteries.

Fig.161-CASEBACK

Fig.162-SEPARATEFRONT

ANDBACK

Fig.163-BATTINSTALLED

a