Octane Fitness PRO3700 Assembly Manual - page 11
11
9. Adjust stride length (optional)
Note: The PRO3700 is initially set to the “Running” stride
length of 24”. To adjust to “Jogging” length (20.5”), follow
these steps:
a. locate the 3-pivot link on the right side of the machine. it
is secured to the pivot arm by 3 bolts and a bracket. For
“Running” stride, the two forward bolts (away from the user)
are inserted in the center and lower holes in the three-pivot
link. For “Jogging” stride, the two forward bolts must be
inserted in the center and upper holes.
b. use 17mm wrenches to loosen bolt “A”, then remove the 2
forward bolts (“b” and “c”).
c. move the 3-pivot link down and insert bolt “b” into the
upper hole and bolt “c” into the center hole in the 3-pivot
link (marked 20.5”); tighten.
d. Repeat steps 1-3 for the left side of the machine.
e. Grasp the plastic shroud “D” at the bottom of the rails and
pull up to remove it.
f. use a 4mm hex wrench to remove bolts “e” and “F” securing
the center track cover “G” to the frame; slide the track cover
down.
f. use a Phillips screwdriver to remove screws “H” and
“i” that secure the stride label badge to the track cover
“G”. turn badge “J” from “Running” to “Jogging”, then
reposition the badge on the cover and secure with screws
“H” and “i”.
g. slide the track cover up into position and secure it with the
bolts “e” and “F”.
h. Reposition the plastic shroud “D” at the bottom of the rails
and press it until it snaps into position.
h. Press and hold the Program and level keys on the console.
Press the up Arrow () key to set the stride length to
“Jogging”, then press enter.
Note: The position of the bolts on both sides of the machine
and the console setting must match (Running or Jogging)
for the unit to work correctly.
A
B
C
D
E
F
G
I
J
G
H