Octane Fitness PRO3700 Assembly Manual

Manual is about: For Ellipticals with Embedded Touch Console

Summary of PRO3700

  • Page 1

    Pro3700

  • Page 2

    2.

  • Page 3

    3 p r o 3 7 0 0 a s s e m b l y i n s t r u c t i o n s personal record keeping tip: record the serial numbers of your octane fitness ® elliptical in the spaces below. This will make it easier for you to obtain accurate and timely response should any service issues occur with your elliptical machine...

  • Page 4

    4 a p r o 3 7 0 0 c o n t e n t s the octane fitness base box contains the following: tools required: a) 1 - octane fitness cross trainer base • phillips screwdriver b) 1 - detached right pedal lever • 17mm wrench or adjustable wrench c) 1 - console mast • 17mm socket and ratchet d) 1 - top cover • ...

  • Page 5

    5 hardware pack (j) includes: k) 8 - 6mm hex key chamfered bolt (for moving handlebars) l) 2 - phillips screws (for mounting access panel) m) 2 - phillips screws with washers (for mounting top cover) n) 1 - cable tie (for securing loose wires to mast) k l m n the pro3700 console box contains the fol...

  • Page 6

    6 1. Attach right pedal lever a. Remove bolt from 3-pivot link. B. Attach right pedal lever (b) to 3-pivot link. C. Tighten the bolt and nut securely using 17mm socket and wrench. 2. Attach moving handlebars—moving handlebars are labeled left and right, be sure to install accordingly. A. Align the b...

  • Page 7

    7 3. Install access panel a. Loosen the screws on the left and right sides of the lower shroud near the front of the unit. (these screws secure the side of the shroud and the access panel to the frame.) b. Slide the metal plate of the access panel (e) behind the back shroud. Fit the tabs on each sid...

  • Page 8

    8 5. Mount the keypad to the console mast a. Remove the two screws securing the console back piece to the mast plate. B. Connect the green grounding wire from the heart rate board to the tab mounted on the frame (next to the green console grounding wire). C. Connect the contact heart rate cables fro...

  • Page 9

    9 6. Mount the console to the console mast note: record the serial number of your console, located on the lower edge of the console, before attaching the console to the console mast. (if you have installed the optional lcd mounting arm, and mounted the console to the mast according to those instruct...

  • Page 10

    10 7. Adjust arms (optional) note: before completing this step, ride the elliptical cross trainer for a few moments to get a feel for the arm motion. If the reach of the arm motion feels right (as it will for most users), proceed to step 8. If the reach is too long or too short, carefully follow the...

  • Page 11

    11 9. Adjust stride length (optional) note: the pro3700 is initially set to the “jogging” stride length of 20.5”. To adjust to “running” length (24”), follow these steps: a. Locate the 3-pivot link on the right side of the machine. It is secured to the pivot arm by 3 bolts and a bracket. For “joggin...

  • Page 12

    12 11. Install mast boot a. Place the rubber mast boot (i) around the mast (c), covering the open ends of the stationary handlebars. B. Tuck the ends of the mast boot (i) into the channels in the access panel (e) just below the stationary handlebars. 10. Place top cover a align top cover (d) on top ...

  • Page 13

    13 13. Adjust levelers a. Adjust the levelers to make sure the product sits flat on the floor. Begin by screwing all four levelers all the way into the machine. If the floor is level, this should be sufficient. If there is some uneveness in the floor, make minor adjustments to the back levelers firs...

  • Page 14: N O T E S

    14 m o v i n g t h e p r o d u c t it is safest to move the product to its installation location in its shipping carton. It may be easier to move the product into your floor space after you remove it from the packaging, but be careful not to hit any walls or doors. The pro3700 features transport whe...

  • Page 15: N O T E S

    15 n o t e s.

  • Page 16: ™

    F u e l y o u r l i f e ™ octane fitness octane fitness international us & canada, latin america, asia & asian pacific europe, middle east, africa 9200 wyoming avenue north rivium weestlaan 19 suite 380 2909 ld, capelle a/d ijssel brooklyn park, mn 55445 the netherlands phone: 888.Octane4 (us and ca...