Octane Fitness PRO3700 Assembly Manual - page 12
12
11. Install mast boot
a. Place the rubber mast boot (i) around the mast (c), covering
the open ends of the stationary handlebars.
b. tuck the ends of the mast boot (i) into the channels in the
access panel (e) just below the stationary handlebars.
10. Place top cover
a Align top cover (D) on top of main housing. Hold the back
edge (near the mast) in place and shift the front edge
forward until it settles into position.
b. While still holding the back edge in place, press firmly on
the bottom edge of the front of the cover until it snaps into
place. You will feel and hear it snap into place as
the plastic bracket on the inside of the front bottom
edge clips onto the steel tube at the front of the main
frame.
c. secure the top cover to the access panel using 2 Phillips
screws with washers (m).
Steel tube
Press here
Hold here
Secure with
screws
12. (Optional) CSAFE Connection
a. if your facility is using csAFe, connect the csAFe
RJ-45 cable to the csAFe port at the base of the machine.
Tug the cable gently to ensure the connector is
completely seated.