Octane Fitness PRO3700 Assembly Manual - page 7
7
3. Install access panel
a. loosen the screws on the left and right sides of the lower
shroud near the front of the unit. (these screws secure the
side of the shroud and the access panel to the frame.)
b. slide the metal plate of the access panel (e) behind the
back shroud. Fit the tabs on each side of the access panel
into the slots between the side of the main shroud and the
frame, over the top of the screws.
b. tighten the screws on each side, then secure the back of
the access panel with 2 Phillips screws (l).
Back
Screws
Tabs
Slot for
Tab
Screw to
loosen on
both sides
Tabs
Metal Plate
(under this edge)
4. Install console mast
a. Attach the console mast (c) by placing the keyhole slots in the
mast plate over the bolts and sliding the console mast toward
the pedals.
b. tighten the four 6mm hex key bolts attaching console mast to
frame.
c. connect all four (4) cable connectors coming from the
mast to the cable connectors on the base frame. Tug the
cables gently to ensure the connectors are completely
seated.
d. use the cable tie (n) to secure any loose cable to the bottom
of the mast; cut off any excess cable tie.
Loosen screw
and fit tab
behind