Octava HDHC48MX-V1.3 Installation manual - page 8
Front Panel Control:
Source Selection:
You may use the front panel buttons to select the sources connected to each
display.
For example,
To Set display A to Input 2. Simply press and release the A display button until
the LED shows 2.
Output Configure:
Configure outputs A and B to either 1) HDMI OR 2) RJ-45 CAT 5/6 output.
Each output is individually configurable.
To configure output, please follow these instructions.
Note : The default from factory is RJ-45 CAT5/6 mode
Output
Mode
Action Indicator
RJ-45 CAT
5/6 mode
Press the front panel button for the
desired output for ~ 10 seconds. The LED
will indicate a “c” for Cat 5/6 mode.
HDMI Mode
Press the front panel button for the
desired output for ~ 10 seconds. The LED
will indicate a “0” for HDMI mode.
quick
configure
To quickly
change ALL
outputs to.
Press and HOLD the front panel A and B
button for 10 seconds.
-The LED will indicate a “c” for Cat 5/6
mode.
-The LED will indicate a “0” for HDMI
mode.
RS232 Controls:
The Octava 4x8 HDMI - CAT 5/6 Matrix Switch can be easily integrated
with 3
rd
Party control systems via RS232 control. The following shows
the control protocol for controlling the HDHC48MX.
1. Baud rate=9600
2. Data bits=8
3. Parity check=None
4. Stop bits=1
5. Flow Control=None
Controlling the HDHC48MX via RS232 can be done by send a series
of commands per the RS232 Command Table
Protocol:
A-General
Input
ASCII
Function Selection
1
Port Status
2
Source display switching
( see page 13)
3
Turn ON LED
4
Turn OFF LED
5
Turn ON Power
6
Turn OFF Power
7
Turn ON Smart Scan
8
Turn OFF Smart Scan
9.
Output(HDMI/Ethernet) Configure
( see page 14)
Note:
12
7