Octava HDHC48MX-V1.3 Installation manual - page 9
Pressing +/-
Increments/Decrements
to the next available
Source.
Remote Control Guide:
Using the Remote:
Use the remote control to select the Display that you wish to control
followed by the Input (DVD, Settop) that you wish to watch.
For example:
-Pressing Display B, “2” will switch Input 2 to HDMI Out B.
Here are some more examples:
7
Press the A button
on the front panel.
LED will flash”0” for
~2 min while
programming.
LED will flash
“0"
while
programming.
8
Wait.
Programming is
complete when LED
indicates “1”
9
Set to LOCK
Position
10
Set output to either
HDMI or CAT5/6
mode
See page 7
Refer to Page 7 “Output
configure”
11
Connect all video
sources and
displays and turn
ON
.
12
Re-power the
Matrix.
Output Selection (Step 1)
Input Selection
(Step2)
Result
DISPLAY A
“2”
Display A switches to Input 2
DISPLAY B
“1”
Display B switches to Input 1
DISPLAY C
“2”
Display C switches to Input 2
DISPLAY D
“1”
Display D switches to Input 1
DISPLAY A
“+”
Display A increments to next
available Input
DISPLAY B
“-”
Display B decrements to next
available Input
DISPLAY C
“+”
Display C increments to next
available Input
DISPLAY D
“-”
Display D decrements to next
available Input
Pressing ON/OFF
Turns On/Off the
HDMI switch
Pressing LED
Turns on/off the
Blue LED light.
Pressing 1-4
Selects the
corresponding
numbered source.
Pressing A-H
Selects the Display
to be controlled.
8
11