OEM Optical IV-CCAM3P Operating Manual - page 19
18
Ø
FLICKERLESS
If the camera is used with 50 Hz fluorescent lighting,
and there is flickering on the monitor.
In this case, set the FLICKERLESS mode to ON.
Otherwise it should be set to off.
1) Position the cursor at FLICKERLESS and press the
left or right direction button for setting the flickerless
on.
2) Press the left or right button again, the flickerless set-
ting is return to off.
Ø
PRESET
This function is useful when the camera is used the
frequently changed setup conditions.
Preset mode provide the best image under the normal
condition by factory setup.
1) When position the cursor at PRESET, " Press SET to
Factory Set" message will be displayed on the
screen.
2) Position the cursor at PRESET and press the Set
button to perform the preset function.
" Factory Setup Completed " message will be
displayed on the screen and the message is
extinguished automatically in about 5 sec.
SPECIAL MENU
Gamma
Color Adj.
Sharpness
: LOW
Contrast
: OFF
Brightness
➔ Flickerless :
ON
Preset
End
SPECIAL MENU
Gamma
Color Adj.
Sharpness
: LOW
Contrast
: OFF
Brightness
Flickerless :
OFF
➔ Preset
End