Ojec-Co H-430RX User Manual - page 13
Page 13 of 15
Other Notes
1.1 Wired trigger flash test. Set the function switch of H-430RX to “Flash -
”, half press the
trigger button, and it will trigger the connected flash.
1.2 Wireless trigger flash test. Set the function switch of H-430TX to “Camera -
”, half press the
trigger button, and it will trigger any flashes that are connected to H-430RXs that are set to “Flash
-
”.
2. Wired Shutter Test. Set the function switch of H-430TX to “Hold -
” and connect this unit to
camera by shutter cable. Half press trigger button and the connected camera focus once. Fully
pressing the trigger button will trigger the camera to shoot once.
3. Incompatible mode wireless flash trigger. If the H-430TX’s “Camera -
” status is in non-
compatible mode with the camera, you must also set the H-430RX ‘s “Flash-
” status to non-
compatible mode to make it work, regardless of whether the H-430RX is compatible with the flash
or not.
4. Non-compatible mode and flash wakeup. If the H-430RX and the attached flash are working in
non-compatible mode, the H-430RX cannot wakeup the flash.
5. The H-430RX ‘s working status indicator lamp. This will flicker approximately every 5 seconds. If
the H-430RX is not in use for a long time, please turn it off.
6. Low Power Indication. When the H-430 working status indicator lamp is red and flickers
approximately every 2 seconds, it means the battery is running out of power and needs replacing
or re-charging in the case of rechargeable batteries.