Ojec-Co H-430RX User Manual - Camera Shutter Triggering
Page 9 of 15
Master camera to control multiple cameras
Place one H-430TX onto the master camera’s hot shoe, set the function switch to “Camera -
”.
With a H-430RX, set the function switch to “FLASH -
” and connect the shutter cable with
“Camera” interface of H-430RX to the shutter interface of the camera.
As the master camera shoots, so the controlled cameras each shoot. This may not perfectly
synchronous, as there may be a slight delay between master and remote camera shutter release.
Camera shutter triggering
Wireless shutter release
1. Single shooting (Set the camera to single shooting mode)
Get one H-430RX and set the function switch to “Camera -
“. Connect the camera shutter cable
with “Camera” interface of H-430RX to the shutter interface of the camera.
Get a H-430TX, set the function switch to “Hold -
”. A half-press of the H-430TX trigger button
will activate the camera auto focus system and the shutter indicator LED of both of the H-430 units
will be green. Press the H-430TX trigger button fully and the shutter indicator LED turns to red,
which will wirelessly trigger the camera shutter for a single shot.