Oki B840dn User Manual - page 21
Menu functions > 21
PCL
EMULATION
This menu controls the printer’s PCL emulation.
JAM RECOVERY
ON
Specifies whether the printer should perform jam
recovery after a paper jam has occurred. If ON, the
printer will attempt to re-print any pages lost due to a
paper jam once the jam has been cleared.
ERROR REPORT
OFF
If ON, the printer will print error details when a
PostScript Emulation error occurs.
Note: Applies to PS & PCL XL only.
ITEM
DEFAULT
REMARKS
FONT SOURCE
RESIDENT
Specifies the location of the PCL default font.
Normally this will be INTERNAL unless additional
fonts are installed in the expansion ROM slot or
additional fonts have been downloaded to RAM as
permanent fonts.
FONT NO.
I0
Sets the current default font number from the
currently selected source.
FONT PITCH
10.00CPI
Sets the width of the PCL default font in characters/
inch (CPI).
Default font is the fixed-pitch, scalable font. The
value is displayed to the second decimal place
Displayed only when the font selected in Font No. is
fixed-spacing, scalable font.
FONT HEIGHT
12.00POINT
Height of the PCL default font.
Note: This menu item is displayed only when the font
selected in Font No. is a proportional-spacing,
scalable font.
SYMBOL SET
PC-8
PCL symbol set. If the font source and number are
changed to one which does not support the selected
symbol set, this must be changed to an available
symbol set for that font.
A4 PRINT WIDTH
78 COLUMN
Sets the number of columns subject to Auto LF with
A4 paper in PCL. This is the value when Auto CR/LF
Mode is set to OFF with the 10CPI character.
WHITE PAGE SKIP
OFF
Selects whether blank pages are printed or not.
CR FUNCTION
CR
Selects whether a received carriage return character
(0Dh) also causes a line feed.
LF FUNCTION
LF
Selects whether a received line feed character (0Ah)
also causes a carriage return.
PRINT MARGIN
NORMAL
Sets the non-printable page area. NORMAL is PCL
compatible.
PEN WIDTH ADJUST
ON
When minimum width is specified in PCL, sometimes
a 1-dot line, looks broken.
With PEN WIDTH Adjust set to ON, when the
minimum width is specified, the line width will be
emphasized so as to look wider than a 1-dot line.
With PEN WIDTH Adjust set to OFF, the line will
appear as before.
ITEM
DEFAULT
REMARKS