Wlan card installation guide gl 4xx e series for printer models: read this installation guide before and during the installation of the above accessory. Keep this installation guide handy for future reference..
2 wlan card installation guide 1 general 1.1 important information this quick guide provides important information on how to setup your new sato product. Be sure to read this quick guide thoroughly before using this printer. It is an integral part of the product and should be kept in the immediate v...
3 wlan card installation guide 1.3 explanation of symbols this instruction manual uses various warning icons to help you understand the safe operation of your printer. Explanations of the icons are below. Warning! Indicates neglectful or erroneous use may cause irreparable damage to the product, ser...
4 wlan card installation guide 1.4 contact and document information . Extensive contact information of worldwide sato operations can be found on the internet at www.Satoworldwide.Com version: si-gl4xxe-01ra-05-06-07-wlcig © copyright 1994 – 2007 all rights reserved. No part of this document may be r...
5 wlan card installation guide figure 1c. Preparing and installing the wlan card gl4xxe wireless lan card installation before installing the wlan card, make sure the printer is off and disconnected from the power supply. Make sure you have discharged any static electricity (by touching a grounded co...
6 wlan card installation guide gl4xxe wireless lan antenna installation after installing the lan card, you will install the antenna for transmission and reception of signals. 1. Screw the antenna into the connector on the wlan card. ( fig 2a) 2. Rotate the antenna so that it points upward. ( fig 2b)...
7 wlan card installation guide once the wlan card is installed, you can access the ethernet settings in the gl’s interfaces mode menu. An overview of the wlan options is listed below: wireless lan card interface setup interfaces interfaces ignore cr/lf item no. Check bcc check history buffer comm. P...
8 wlan card installation guide permits entry into the interfaces mode. Interfaces is the menu selection screen for the interfaces mode. Interfaces ignore cr/lf item no. Check bcc check history buffer comm. Protocol host interface ethernet port ethernet setting wlan address wlan setting parallel port...
9 wlan card installation guide menu screen what the options mean communication protocol. Selects the mode of bi-directional communications. In most cases this menu does not need to be altered and is meant to help support legacy applications which may have incorporated older bi-directional statuses. ...
10 wlan card installation guide determines how the printer and/or nic card respond when a job has been completed. The definition of a complete job is also determined by this setting. • standard - factory default. The nic card responds to the host that the job is complete when job control standard* o...
11 wlan card installation guide this menu allows the subnet mask for the tcp/ip protocol to be set in four three-digit segments (seg1 through seg4). If the subnet mask is assigned by bootp, arp, or dhcp, it is dynamic and read only. When changing the subnet mask, the printer resets the network inter...
12 wlan card installation guide allows selection of the way the wireless option communicates. • infrastructure - factory default. The wireless option must go through an access point. Operation mode infrastructure * ssid name ssid name (01 – 15) ssid name (16 – 30) ssid name (31 – 32) • pseudo ibss -...
13 wlan card installation guide power management. This menu allows the power-save and sleep modes to be set. The value set wil be in milliseconds. If set to zero, the power-save mode will be disabled. Power mgt 0 ms. * the allowable range is 0 to 1000 ms., and the factory default is 0 ms.. Transit p...
14 wlan card installation guide.
