1 rfid kit installation guide read this installation guide before and during the installation of the above accessory. Keep this installation guide handy for future reference. For printer models: for printer models: gl 4xx e series.
2 1 general 1.1 important information this quick guide provides important information on how to setup your new sato product. Be sure to read this quick guide thoroughly before using this printer. It is an integral part of the product and should be kept in the immediate vicinity of the device and ava...
3 1.3 explanation of symbols this instruction manual uses various warning icons to help you understand the safe operation of your printer. Explanations of the icons are below. Warning! Indicates neglectful or erroneous use may cause irreparable damage to the product, serious injury to the operator, ...
4 1.4 contact and document information . Extensive contact information of worldwide sato operations can be found on the internet at www.Satoworldwide.Com version: si-gl4xxe-01ra-12-06-07-rfkig © copyright 1994 – 2007 all rights reserved. No part of this document may be reproduced or issued to third ...
5 step instructions & tools image(s) gl4xxe rfid kit installation the complete rfid kit for the gl consists of five (5) parts: four parts from the main rfid kit and one part containing the rfid reader module from awid. All five parts must be available before installation. Installation involves five ...
6 removing the front cover tool(s) required flat blade screwdriver (recommended) 1. Loosen and remove the thumbscrew fastener that secures the front cover. 2. Pull the outer edge of the front cover outwards, and then push the entire cover in the direction shown by the arrow. The cover will be dislod...
7 2 removing the print head 1. Release the print head assembly by turning the head lock latch counterclockwise. 2. Press the spring-loaded tab as indicated here, to release the print head. 3. Disconnect the data and power cables from the print head. 4. Set the print head aside for now. Note: esd (el...
8 3 installing the antenna part(s) required antenna assy, rfid, sl4m screw, 6-19 hl x 1/2, phcr, ss410, ansi b18.6.4 tool(s) required #1 phillips + screwdriver - 12 in. Lb 1. Remove the gap sensor paddle (circled red) by sliding it out. Set the gap sensor paddle aside for later use. 2. Remove the me...
9 4 assembling the reader module parts required reader mount subassembly, gl4xxe tool(s) required #1 phillips + screwdriver - 8 in. Lb. 1. Plug the antenna cable into the port on the right side of the reader subassembly as indicated in figure 4a. 2. Route the other end of the cable into the electron...
10 setting the country frequency when the rfid kit is installed, the printer will automatically be set to use the country frequency of the antenna module. However, if the error message “rfid freq bandl /unknown” appears, see below: 1. If the rfid freq band: / unknown message appears after the printe...
11.
