Internal rewinder-dispenser installation guide for printer models: gl 4xx e series read this installation guide before and during the installation of the above accessory. Keep this installation guide handy for future reference..
2 1 general 1.1 important information this quick guide provides important information on how to setup your new sato product. Be sure to read this quick guide thoroughly before using this printer. It is an integral part of the product and should be kept in the immediate vicinity of the device and ava...
3 1.3 explanation of symbols this instruction manual uses various warning icons to help you understand the safe operation of your printer. Explanations of the icons are below. Warning! Indicates neglectful or erroneous use may cause irreparable damage to the product, serious injury to the operator, ...
4 1.4 contact and document information . Extensive contact information of worldwide sato operations can be found on the internet at www.Satoworldwide.Com version: si-gl4xxe-01ra-05-06-07-irwig © copyright 1994 – 2007 all rights reserved. No part of this document may be reproduced or issued to third ...
5 1) removing the base of the printer make sure the printer is off and disconnected from the power supply and all other cables. Remove the side cover using a #2 phillips screwdriver to remove three screws as circled in orange. Keep these screws aside for later use when putting back the side cover. S...
6 1) removing the base of the printer (cont’d) the front cover can now be removed. Remove the lock shaft located at the front of printer. (do not lose this part as it is essential for the installation of dispenser option) note this lock shaft must be removed for the successful installation of the in...
7 1) removing the base of the printer (cont’d) the fifth screw to be removed is shown here. The sixth and seventh screws are shown here, securing the base to the front of the chassis. The last two screws are on the electronic section as circled here in orange. Figure 1e. Removing the fifth of nine s...
8 1) removing the base of the printer (cont’d) finally, carefully separate the base plate of the printer from the main chassis. This can be done by placing the printer on its side and pulling the base plate out. Figure 1h. Separating the base from the printer.
9 図 ﾌﾛﾝﾄｶﾊﾞｰ sensor cable 2) mounting the printer above the rewinder-dispenser to facilitate easier mounting, it is recommended that you remove the front cover of the internal rewinder-dispenser beforehand. Pull down the side cover of the internal rewinder and remove two bind screws (m4x4) located a...
10 ｺﾈｸﾀｰ 1) mounting the printer above the rewinder a total of seven screws (cross recessed hexagonal bolt m4x10) are used to install the internal rewinder-dispenser to the printer chassis (do not damage the pcb when using any tool such as screwdriver) do not tighten all seven screws until you are s...
11 1) mounting the printer above the rewinder (cont’d) if the front cover snaps into place correctly, you can proceed to further tighten the screws permanently, followed by inserting the thumbscrew used to secure the printer’s front cover in the first step of this guide. Finally, connect the printer...
12 liner adjust collar dispenser 3) mechanical adjustment of the dispenser turn the printer on and take it offline (by pressing the line button). Go into the printer’s advanced mode and scroll to the media handling menu. Select peel-off to activate the peel-off and rewinder functions, and then exit ...
13.
