Oki GL408e Install Manual - page 10
10
Setting the Country Frequency
When the RFID kit is installed, the printer will automatically be set to use the Country Frequency of the antenna
module. However, if the error message “RFID Freq BandL /Unknown” appears, see below:
1. If the RFID Freq Band: / Unknown message appears after the printer reboots, go to step 4.
2. Press the Up, Down, Left, and Right keys at the same time to access the factory Menus.
3. Press the Up key until RFID Freq Band displays.
4. Press the Down and
ENTER
key at the same time until the message ENTER SWITCH
UNLOCKED is displayed
.
5. Press the Left or Right key until the correct menu item for your country displays. See Table 1.
6.
Press ENTER to select the frequency.
7. Turn the printer OFF and then ON to restart it.
Table 1. Country/Frequency Selection
Country
Menu Item
Frequency (MHz)
Hong Kong
920-925 H.Kong
920 to 925
Taiwan
Taiwan 7
923.6 to 926.5
United States/Canada
902-928 US 1
902 to 928
5
Reassembly
Tools required
#1 Phillips + screwdriver - 8 in. lb.
1.
Pull any slack interface cable
slack back into the
electronics compartment of
the printer.
2.
Put back the side cover that
was removed in Step 3
(page 6).
3.
Tighten and torque screws.
4.
Put back the front cover that
was removed in Step 2.
5.
Re-install the gap sensor
paddle in the reverse order
of removal.
6.
Close the media cover.