Oki OKIPAGE18n Quick Start Manual - page 17

Quick Start

|

E-17

2 Insert the connector; secure with the screws.

3 Attach to the computer and tighten the screws.

!

 Be sure not to over-tighten the screws–this could damage

the screw posts on your computer.

4 Turn the printer and computer on.

!

 For Serial Interface pin assignments, see Interface in the

Specifications section of the User’s Guide.

Cable Requirements

· Cable must be shielded with twisted pair conductors and

must be UL and CSA approved.

· Maximum length for serial cable is 6 feet (1.8 meters).

· Printer connector is Type 17LE-13250-27 (D4CC)

receptacle (25 pins).

Standard RS232-C Serial Menu Settings

Flow Control = DTR Hi

Baud Rate = 9600 Baud

Data Bits = 8 Bits

Parity = None

Min. Busy = 200 mSeconds

!

 To change any of these settings, see PrinterMenus in the

PrinterControl section of the User’s Guide.