Pacific Energy BROADWAY Installation And Operating Instructions Manual - Levelling Legs
9
161204-24
# 5055.6591
Levelling Legs
Levelling legs are provided as a convenient means
for levelling the appliance when it is installed on
an irregular surface. The legs (3" long threaded
bolts) can be found packaged inside the appliance.
From the underside, thread the legs into the holes
into the base, near the back of the appliance. .
The legs thread into the nuts and protrude out the
bottom, raising the rear of the appliance until it is
level with the front.
Burner Removal
Caution: Turn off gas and electrical power sup-
ply and allow ample time for unit to cool before
proceeding.
1) Remove the window as per previous section.
Place the glass frame assembly in a safe place
to avoid damage.
2) Note logs position and carefully remove, taking
care not to damage them.
3) Remove two screws securing the burner. Lift
out burner. (see fi g # 13).
Glass Frame
Removal/Installation
Warning: Turn off the fi replace and allow ample time
to cool before proceeding.
Caution: The ceramic glass panel is very fragile, and
should be handled with care.
The window frame assembly is held in place by two
spring loaded latches and are operated by a removable
handle.
1) Open control access doors on either side of the
fi replace to gain easy acess to the window latches.
2) Insert the latch handle onto the catch located 2" down
from the top corners. rotate up to disengage each of
the two catches.(Fig # 12)
3) Tilt the top of the window frame out to clear the top
of the fi replace . Grasp the sides of the frame and
lift up and out to disengage from its bottom track.
4) Reassemble in reverse order.
Fig # 12
Fig # 13
Two screws