Pacojet PACOJET 2 Instruction Manual - page 9
16
17
Control panel
5.3
The PACOJET 2 control panel has two function buttons: START and STOP/
RESET/HOME. It also features a high resolution colour screen, four selector
buttons for display functions and two buttons with arrows for increasing and
decreasing settings. The following sections describe these in greater detail.
START button
5.4
The START button is used to begin a processing
cycle. Before a processing cycle can begin, a paco-
tizing beaker must be inserted within the protective
outer beaker and mounted in place and the ma-
chine must be in ready mode.
When the START button has been pressed, the
processing cycle begins, meaning the blade at-
tached to the shaft will rotate while descending to
the bottom of the beaker. The processing cycle can
take place with normal or overpressure according to
the chosen settings. When the designated portions
or the entire contents of the beaker have been proc-
essed, the shaft with the attached blade, ascend to
their starting position, the beaker is automatically
depressurized and the processing cycle ends. The
PACOJET 2 machine remains in ready mode.
STOP/RESET/HOME button
5.5
The STOP/RESET/HOME button can be used to:
interrupt a processing cycle that is in progress
•
(press during a cycle to stop the process)
reset previously selected pacotizing options
•
(press during ready mode to reset)
return to the home screen (press within settings
•
mode to return to the home screen)
Pressing the STOP/RESET/HOME button during
a pactotizing cycle will immediately command the
shaft and pacotizing blades to retract to the starting
position (UP/DOWN graphic, section 5.9), and au-
tomatically end the cycle. This method of operation
permitsprocessingrandomquantitiesofthebeaker
content, i.e. without preselected portions.
Display screen functions and navigation
5.6
Utilizing the ON/OFF switch to power on the
PACOJET 2, the display will show the PACOJET
logo for several seconds. Immediately following, the
home screen will load, which features 3 process-
ing mode icons and an icon to access cleaning and
machine settings functions. From this home screen,
the PACOJET 2 can now be set/programmed for
theprocessesrequired.
Processing modes
5.7
The 3 processing mode icons represent the 3
processing modes available : Pacotizing, Chopping/
Cutting and Mixing/Whipping. When powering on
the PACOJET 2 utilizing the ON/OFF switch, the
home screen will appear after the PACOJET logo,
on which the pacotizing mode is selected as the
default.
Function buttons
START
Colour screen
Selector buttons
Selector buttons
Arrows
STOP/RESET/HOME