Plinius P7 Instruction Manual - page 5
Plinius P7 instruction manual. Page 5
QUALITY of the connections must be examined to ensure a high performance, trouble
free operation is enjoyed. Check that the connections are tight, but do not overtighten
with excessive use of spanners etc. If bare wires are used, make sure that no loose strands
of wire short across to the other terminals or the amplifier chassis.
When using plugs such as Banana, be sure to use good quality one's with a firm fit.
Output connections are provided to allow the use of most types of high quality loudspeaker cables.
The terminals are very robust 5 way binding posts which allow the use of banana plugs, bare wires, pins,
spades and looped wire or terminals. Do not over tighten these terminals.
STEREO. This P7 is a dual channel or stereo amplifier.
Both left channel and right channel signals are amplified and output to a stereo pair of
loudspeakers. This is the most common use of this power amplifier.
UNBALANCED or single-ended or RCA or coaxial leads are the most common of all and
are used in the majority of audio signal systems. The terminal plug and socket are most
commonly called RCA and can be found on the P7 for use as the standard input terminals
for both Left and Right inputs.
REAR PANEL LAYOUT
INSTALLATION & OPERATION
MAINS VOLTAGE.
CHECK that the mains voltage printed on the rear of this amplifier is similar to the mains voltage
normally supplied to your area.
If in doubt, please consult your
PLINIUS
dealer.