Plinius P7 Instruction Manual - page 8
Plinius P7 instruction manual. Page 8
LOUDSPEAKERS
This amplifier is designed for use with HiFi quality loudspeakers. It should not be used to operate with
any other type of appliance or equipment not intended or designed for use with this amplifier.
Choice of loudspeakers is one of personal taste, providing the chosen loudspeakers are suitable for use
with this control amplifier. Be certain that your loudspeakers can handle most of the rated output power
of this amplifier. Your may find loudspeaker
specifications confusing or misleading therefore you should discuss these fully with your audio dealer
prior to purchase. The use of higher power (100 Watts RMS or greater)
loudspeakers are recommended for this amplifier in stereo mode. Our experience indicates that low power
loudspeakers are quite often suitable for use with this amplifier provided the volume is maintained at a
level where no distortion is audible.
Impedance of the loudspeaker load is important to ensure the rated performance of this amplifier. Any
combination of loudspeakers may be used but the total average impedance load for each channel should be
within a range of 4 to 8 Ohms in stereo mode.
SERVICING.
If the top cover of the P7 amplifier is taken off for any reason, remove the mains supply
plug first. The Voltages present on the circuit board could be harmful.
In the unlikely event that your PLINIUS P7 should require any service please take it firstly
to your Dealer in its original packaging. They will then determine if the unit should be
returned to the factory. Your PLINIUS Dealer has a good understanding of our
Amplifiers and will be able to advise on any further installation requirements.
CLEANING.
A damp cloth is all that is required to remove dust and finger marks from the P7’s
anodised surface.