Pneumercator ETD1000 Instruction Manual - page 25
ETD1000 Instruction Manual - 2017-07-01.docx
Page 25 of 28
July 1, 2017
4.0 Front Panel Operation – Operator Mode
Alarm LEDs*
Display Mode LEDs
LEAK
– In-Tank Leak
GAL
– Gross Volume (Gal/Ltr)
Net Volume (with ºF/ºC LED on)
SP1
– Above 95% (High High)**
%GAL – Percent of Capacity
SP2
– Above 90% (High)**
ULL
– Ullage Vol (Gal/Ltr, Default 90%)
SP3
– Below 20% (Low)**
IN
– Product Level (in/mm)
Water Level (with “u” symbol, in/mm)
WATER – Above 2”**
ºF
– Product Temperature (ºF/ºC)
Front Panel Buttons
MODE
TANK SELECT
TEST
Press to display tank name.
Press to select tank
Press to test
Press and hold until beep
Press and hold until
display and
to select display mode
beep for autoscan
horn
* If an alarm LED is blinking, an active tank alarm is present on a tank(s) not currently being displayed. When
an alarm LED is on continuously, it applies to the currently displayed tank. Note that this alarm may apply to
more than one tank, which can be determined by viewing each tank with the TANK SELECT button.
** Factory defaults shown. Other values and may be programmed.
Audible Alarm
Acknowledgment
To silence an alarm,
press any of the buttons.
The visual indicator will
remain active as long as
the alarm condition
persists.