Table of contents 1. What’s in the box 2. Warning 2. Safety instruction 2. Overview 3. Quick start guide 4. Rear panel layout 4. Front panel controls 4. Display modes 6. Additional display notifications 6. Setup display mode 8. Servo system 9. Multiwave ii 10. Troubleshooting guide 11. Specification...
Warning to prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the enclosure. Refer ser- vicing to qualified personnel only. To prevent electric shock, use a 3 prong, grounded type power cable. Any change or modifications not expressly app...
• up to 1000 watts power delivery - depending on load requirements.* • next generation multiwave ii technology featur- ing autowave and tubewave. • independent power zones keep power for ana- log, digital and high current equipment electrically isolated. • regenerated ac delivered through 8 power po...
1. Filtered ac zone one power port duplex receptacle provides two outlets for filtered ac. The filtered ac zone will pass as much current as a 15 amp wall receptacle can provide, up to 1800 watts. The controls for frequency, voltage, and multiwave setting do not affect the filtered ac zone outlets. ...
Front panel controls there are five buttons on the front panel of the power plant p1000. 1. Power 2. Mode down 3. Mode up 4. Edit down 5. Edit up power on/off the power button will activate the front panel dis- play and output ac power to the regenerated ac zones. Power will continue to pass through...
• 100 volt model ranges from 95 - 105 v default setting is 100 volts. • 120 volt model ranges from 100 - 120 v default setting is 117 volts. • 240 volt model ranges from 220 - 240 v default setting is 240 volts. (adjustments in 2 volt increments) as long as the voltage to the power plant does not de...
Setup display mode there are 5 additional parameters that you can access in the setup display mode. The setup display mode can be activated by pressing the mode up and mode down buttons simultaneously while powering on the p1000. Pressing mode up/down will scroll through the 5 setup parameters. The ...
Multiwave ii multiwave ii is a technology available exclusively on the newest ps audio power plant series of ac regenerators. The p1000 includes multiwave ii and also features autowave and tubewave. There are 4 multiwave ii waveforms as well as tubewave, autowave and sinewave mode. Multiwave ii is o...
[auto] autowave this revolutionary new process automatically computes the best multiwave ii setting for a par- ticular power load as presented by the connected equipment. The beauty of this system is its ability to instantly change the power setting of the ac regenerator with the dynamic load variat...
Up the p1000. If the filtered ac outlets still do not pass ac, please contact your dealer for additional service. The p1000 seems to be working, but the dis- play is blank the p1000 may be in the display blanking mode. Press the mode up or down buttons on the front panel and the display should turn ...
Off using the front panel power button, let it sit for a few seconds and power it back up. If the “fault” message continues to appear, please contact your dealer for additional service. How do i reset the settings to factory default? The p1000 was designed to easily reset the micro- processor back t...
Ps audio international, inc. 4826 sterling dr. Boulder, co 80301 usa toll free: 877-772-8340 ph: 720-406-8946 fax: 720-406-8967 www.Psaudio.Com 12.
