PS Audio Power Plant P1000 Operation Manual - page 7
Setup Display Mode
There are 5 additional parameters that you can
access in the setup display mode.
The setup display mode can be activated by
pressing the Mode Up and Mode Down buttons
simultaneously while powering on the P1000.
Pressing Mode Up/Down will scroll through the 5
setup parameters. The 4-setup parameters are:
1. Software version
[VER.]
2. Network Address
[N ADR]
3. Network Group
[N GRP]
4. Network Power On/Off
[N PWR]
5. Reset
[RESET]
To exit the setup menu at any time, power down
the P1000 and all changes will be saved.
Software version
This mode will display the current version of the
P1000 operation software. Press the Edit Up/
Down key to display the version number. This
mode cannot be edited.
Network Address
If more than one piece of PS Audio equipment is
used in a system, then each piece connected to
the PS Bus must have a unique Network Address.
In this way, each piece of PS Audio equipment can
easily be recognized and identified in the Network
Bus. There are 8 possible Addresses (1-8) which
can be selected by pressing the Edit Up/Down
buttons when in the Network Address mode.
If no Network Address is set then the P1000 will
operate independently of any other PS Audio
equipment on the PS Bus.
Network Group
It is possible to assign the P1000 to a unique
Network Group. There are 3 possible groups
which can be selected by pressing the Edit Up/
Down buttons when in the Network Group mode.
If it is necessary to have more than one Group on
the PS Bus then, all PS Audio products can exist
on the same PS Bus yet communicate in separate
groups.
Network Power
The Network Power setting will alter which PS
products will be affected by the power status of
the P1000. It can be set to Power or Global.
If set to Power, the P1000 will control the power
status of other PS Audio “power” products on the
same Network Group. If set to Global, it will con-
trol the power status of all products on that Net-
work Group. The default setting is Power.
Reset
If at any time it is necessary to reset all of parame-
ters of the P1000 to their default settings, it can be
done by pressing the Edit Up/Down button twice
while in RESET mode. See Also the troubleshoot-
ing guide.
7