Q-See QT5116 User Manual - Getting Started
GETTING STARTED
QT518 & QT5116 User Manual
9 |
P a g e
2.4 Remote Control
The remote control uses two AAA size batteries. Instructions for operation are as follows:
Step 1: Open the cover of the Remote Control
Step 2: Place batteries making sure the poles are correct (+ and -) and replace battery cover.
If the remote does not work check the following prior to contacting Q-See for a replacement remote control:
1. Check the pole position of the batteries
2. Check the remaining charge in the batteries
3. Check to make sure the sensor on the DVR is clear
Figure 2-11 below illustrates the Remote Control functions as follows:
Fig 0.11: Remote Control
ITEM
PHYSICAL CONNECTOR
CONNECTOR DESCRIPTION
1
POWER BUTTON
Push once to stop firmware running. Hold down button to turn off the DVR.
2
INFO BUTTON
Get information about the DVR like firmware version, HDD information
3
REC BUTTON
To record manually
4
NUMBER BUTTONS
Input numbers or choose camera
5
MULTI SCREEN BUTTON
To choose multi screen display mode
6
SEARCH BUTTON
To enter search mode
7
MENU BUTTON
To enter menu
8
ENTER BUTTON
To confirm the choice or setup
9
DIRECTION BUTTON
Move cursor in setup or move PTZ camera
10
+/- BUTTON
To increase or decrease the value in setup
11
PLAYBACK CONTROL BUTTON To control playback, Fast forward/rewind/stop/single frame play
12
AUDIO BUTTON
To enable audio output in live mode
13
AUTO DWELL BUTTON
To enter auto dwell mode
14
BACKUP BUTTON
To enter backup mode
15
PTZ CONTROL BUTTON
To control PTZ camera: Move camera/ZOOM/FOCUS/IRIS/SPEED control