Q-See QT5116 User Manual - Basic Functions
BASIC FUNCTIONS
QT518 & QT5116 User Manual
19 |
P a g e
Fig 3.12: Motion Detection Area Setup
Step 3: Enter Trigger configuration, see Fig 3.13: Alarm Out Setup.
Fig 3.13: Alarm Out Setup
Step 4: Select alarm out and recording channels. This will trigger cameras to record once motion is detected.
Step 5: Enable or disable Buzzer on board. Select speed dome (PTZ) and enable preset or auto cruise. Press OK to
save
Step 6: Set Hold time. It is the interval time between two consecutive motion events. If a second motion event is
detected during the Hold time, it is recognized as a continuation of the first motion event. If a second motion is
detected after Hold time, this motion and the previous are recognized as two different motion events.
Step 7: Click OK to save settings.
Step 8: Enter SCHEDULE configuration. Select Motion and relative cameras to set.
Note: Users can not chose the preset and auto cruise options at the same time.